(dB) A customary logarithmic measure most commonly used (in various ways) for measuring sound. Decibel is a way to express the ratio of two sound intensities: dB=10log10I1/I2 being I1 the reference. If one sound is 1 bel (10 decibel) 'louder' than another, this means the louder sound is 10 times louder than the fainter one. A difference of 20 decibel corresponds to an increase of 10 x 10 or 100 times in intensity.
The intensity of ultrasound decreases during the propagation and is measured in db/cm.
For sound pressure (the pressure exerted by the sound waves) 0 decibel equals 20 microPascal (μPa), and for ultrasonic power 0 decibel sometimes equals 1 picoWatt.

See also dB/dt, Phon, and Logarithms.

A logarithmic measure of sound loudness closely related to the decibel. The unit decibel is used for objective measurements, that means, they measure the actual pressure of the sound waves as recorded using a microphone. The unit phon is used for subjective measurements, which means, measurements made using the ears of a human listener.
A sound has the loudness 'p' phon if it seems to the listener to be equal in loudness to the sound of a pure tone of the frequency 1 kilohertz and strength 'p' decibel. A measurement in phons will be similar to a measurement in decibel, but not identical, since the perceived loudness of a sound depends on the distribution of frequencies in the sound as well as the pressure of the sound waves. In the U.S., sound loudness is frequently measured in sones rather than phons: a sound of loudness x sones has loudness 10 log2 x + 40 phons.

See also Acoustic Noise.

A logarithm (log) of a number x is defined by the following equations. If x = 10y then log(x) = y.
A useful application of base ten logarithms is the concept of a decibel. A decibel is a logarithmic representation of a ratio of two quantities.

(SNR) Signal to Noise Ratio is the ratio of the amplitude of a signal to undesired noise. The larger the signal noise ratio, the easier is the detection and measurement of a signal. The sensitivity of any device is limited by the SNR. The SNR for sound is often expressed in decibel.

Sound and ultrasound waves consist of a mechanical disturbance of a medium such as air. The disturbance passes through the medium at a fixed speed causing vibration. The rate at which the particles vibrate is the frequency, measured in cycles per second or Hertz (Hz).
The pressure of sound is reported on a logarithmic scale called sound-pressure level, expressed in decibel (dB) referenced to the weakest audible 1 000 Hz sound pressure of 2*10^-5 Pascal (20 mP). Sound level meters contain filters that simulate the ear's frequency response. The most commonly used filter provides what is called 'A' weighting, with the letter 'A' appended to the dB units, i.e. dBA.
Sound becomes inaudible to the human ear above about 20 kHz and is then known as ultrasound. Diagnostic imaging uses much higher frequencies, in the order of MHz.
See also Spatial Peak Intensity.

Sound frequencies: